平成14年度研究報告 VOL.52  
研究

 二酸化チタン光触媒皮膜の形成とその機能性評価
 化学食品部 ○中村静夫 勝山陽子 藤島夕喜代 豊田丈紫
 金沢大学 清水宣明
 金沢工業大学 大橋憲太郎

 本研究では,二酸化チタン光触媒コーティング液の簡便な作製と各種基板上に形成した皮膜の触媒機能評価方法について検討した。また,紫外線以外の二酸化チタンの励起源についても調査した。得られた結果は以下の通りである。(1)二酸化チタンの有機化合物を用いて光触媒コーティング溶液が容易に作製できた。(2)XRD分析の結果から熱処理温度は約500℃で,コーティングの繰り返しは3回以上が望ましかった。(3)暴露試験,メチレンブルー法,ガスバッグ法の何れでも光触媒効果が確認された。(4)二酸化チタンは,超音波からの励起エネルギーを受けても,紫外線と同様の触媒作用を示すことが判った。

キーワード
  二酸化チタン,光触媒,超音波



 Formation of Titanium Dioxide Photocatalytic Film and Its Criticism of Functionality
 Shizuo NAKAMURA, Youko KATUYAMA, Yukiyo FUJISHIMA, Takeshi TOYOTA, Noriaki SHIMIZU and Kentaro OOHASHI

 In this study, the convenient synthesis of the titanium dioxide photocatalytic solution was tried, and the films produced by this synthesis were evaluated as the photocatalyst. Also an excitation source of titanium dioxide other than the ultraviolet ray was examined. The following results were obtained. (1)The solution of the photocatalyst was easily synthesized by using organic compounds of titanium dioxide. (2)The result of the XRD analysis showed that heat treatment temperature of about 500℃, and the coating over three times to the substrate were effective. (3)The photocatalytic effect of films was confirmed by all ways of the gas pack method, the methylene blue method and the exposure test. (4)The excitation energy from the ultrasonic wave provided titanium dioxide with the catalysis, as well as that of ultraviolet ray.

Keywords
  titanium dioxide, photocatalyst, ultrasonic wave


全文 (PDFファイル:281KB、6ページ)
  簡易テキスト版

PDFファイルをご覧になるためには、アクロバットリーダーが必要です。
ダウンロードはこちら


* トップページ
* 研究報告もくじ

*

前のページ

* 次のページ